When I turn on my shark lift away, the lights will come on but the vacuum doesn’t do anything. It doesn’t make any noise, the brush doesn’t move but the lights do come on very bright. Any suggestions of what could be wrong?
Esta é uma boa pergunta?
Rep: 784,3 mil
1,1 mil
894
2,3 mil
@skelly64 use something like this video to work on your vacuum. Since your lights are bright, and you seem to think brighter than usual, I would suggest that you use a multimeter and check if there is actually power going to the motor. Once you have your vacuum partially disassembled it might help you out if you post pictures so we can continue to guide you Adicionar imagens a uma pergunta já existente All you should need for this check would be your basic hand tools (screwdrivers etc.) and a run of the mill multimeter. Nothing fancy.
Esta resposta foi útil?
Rep: 4 mil
3
3
motor bad, brushes jammed causing the overload to trip, or an interlock switch open because it is bad or the parts are not assembled correctly.
Esta resposta foi útil?
Últimas 24 horas: 7
Últimos 7 dias: 33
Últimos 30 dias: 138
Duração total: 1,496
