Rep: 1
4
3
Hello.
I have a iphone 6 with weird value on PP1v8 power rail.
It should show 1,8 V but it is showing 2,70 V . Does anybody have similar issue ?
DCPS show’s 0 Amp’s before powering it up.
PP_VCC_Main - OK
PP_BAT_VCC - OK
DCPS after pressing power button constant 0,22 Amp.
Esta é uma boa pergunta?
Rep: 34,7 mil
10
22
44
Is it showing image or taking charging current through a usb amp meter
Esta resposta foi útil?
Hei,
From the board right now is missing Tristar, Backlight IC and Display IC.
Should it be still showing normal values on PP1v8?
I would replace the 3 to see what happens after
But still - Shouldnt the PP1v8 still be 1,8 Volt's even if these chips are missing.
What component are you testing for 1v8
Rep: 2,4 mil
4
1
1
Some where 3v connect to 1.8 that value shows 2.7.I also faced the same problem but i can`t solve it.I think under layer of the phone is shorted i think.
Esta resposta foi útil?
Últimas 24 horas: 0
Últimos 7 dias: 7
Últimos 30 dias: 9
Duração total: 114
1 comentário
Diode mode shows a good value as 339 ( ZXW shows 313), this small differenece cant be issue ?
Measured the cap near to nand.
por Kaspar