Rep: 9
1
I used the instructions to go step by step to replace the ring/vibrate switch on my iphone 3g but now the video doesn't work - it is on, it shows up in iTunes but the screen does not respond and is black. Thanks for your help.
Andrew
Esta é uma boa pergunta?
Rep: 1,6 mil
12
13
Best to totally retrace your steps.
Hopefully you have not assembled it completely (but that is too much to hope for)
You most likely have disconnected the display unit or damaged the ribbon cable for it - the only way to find out is to visual inspect it. The connector may just have come off the logic board.
Good Luck
Esta resposta foi útil?
thanks, I will give it another try tomorrow.
Últimas 24 horas: 0
Últimos 7 dias: 3
Últimos 30 dias: 3
Duração total: 1,312
1 comentário
It was the video cable. It seemed to be clicked in to the board, but you can give it just a bit more. That's what it needed. BTW, I am having to restore the software now too, oh well at least I didn't brick it!
por Andrew