Rep: 49
2
Hi. I have been repairing an ipad air 2 and noticed that my replacement bonded digitizer and screen assembly came with a small flap with 4 solder points on it. Upon inspection of the broken part it became apparent that a small printed circuit was soldered to the flap with an IC on it. my guess it has something to do with cover to sleep the pad, can anyone confirm this please. Thank you.
Esta é uma boa pergunta?
Rep: 469
7
2
Yes, those components are necessary for the smart cover to work. If the part that you received doesn't have them, then you should return them for an exchange or purchase from another supplier.
Esta resposta foi útil?
Or - like I just did - remove the IC from the old screen by hotair(I used 300C for 2 sec) and resolder it to the pads on the new screen.
@ anders.. did it work?
Rep: 73,8 mil
19
111
82
Yes that is one of the hall effect sensor for the smart cover.
Esta resposta foi útil?
Rep: 1
1
Has Anyone found a supplier for these chips?
Esta resposta foi útil?
Últimas 24 horas: 0
Últimos 7 dias: 2
Últimos 30 dias: 3
Duração total: 758
1 comentário
Does your unit work without the small ic?
por Loren Robinson