Desmontagens nas quais trabalhei
Meus guias favoritos
Guias concluídos
Minhas Histórias
Perguntas
-
won't boot from floppy, get error 41 when boot from HDHere's a question for the "greybeards" out there: I have a PowerBook 5300c, which when I attempt to boot it normally, gets an...
Respostas
-
Responder a: No phone connection after changing batteryThe antenna connector is probably the most difficult one to attach. just keep at it, gently, and it will eventually seat. I have the best luck using my fingers instead of a tool, so I can feel if I am getting the alignment correct. I have big hands, so I always seem to have trouble with antenna cables.
-
Responder a: replace ssd on this iMac 20"looks like it should be low profile enough to fit in the same space as the regular HDD
-
Responder a: Mac Mini 3,1 fan 0 rpm after I install SSDThe fan should spin at max RPM if any temp sensor is not detected, as a failsafe. Is something interfering with the fan mechanically? The SSD should draw less power than a regular HDD, so I am wondering if this might be mechanical and not electrical. You can run the unit without reassembling it to see if a cable or the SSD housing is interfering. I can't image the SSD housing is causing a problem, but you never know.
-
Responder a: Are two dram modules requiredYou can run with just one RAM module, but you will get the best performance by installing a matched pair (same size, same manufacturer). This allows the Mac to interleave the RAM, essentially doubling the speed the CPU can access memory.
-
Responder a: Laptop won't boot. LCD screen & Apple logo on top cover won't light upDo you get a boot chime? If so, shine a bright light on the screen after powering it on and look for an image on your screen. It may just be that your backlight has failed. Optionally, connect an external display and check for video. Also try booting with no battery installed - sometimes a bad battery will pull down the entire power circuit.
-
Responder a: What order do I go in to replace these parts?I would do fans, then hard drive, and end with RAM. You don't need to remove any of these items to replace the others, but you do have to remove the left i/o board to get to the left fan, so might as well start with the hardest step first.
-
Responder a: My lap top not turn on.Sounds like possible liquid damage
-
Responder a: My internal hard disk is 0 byte and a flashing question markYour internal hard drive has definitely failed - try booting the computer from DVD after disconnecting the hard drive cable from the logic board. Do you have the original restore discs for this computer? It requires 10.6.3 minimum, and a Snow Leopard retail DVD would not necessarily boot the computer. There are two revisions of the Snow Leopard DVD - 10.6.0 and 10.6.3. If you have access to another Mac, try creating a Lion or Mountain Lion DVD to test with. Sleep mode would not cause a hard drive failure, as the drive heads are parked just as if the computer was powered off. A drop or strike, however, could be the culprit. If you have AppleCare on this computer, I recommend taking it to an Apple Store or Authorized service provide and let them deal with it for you for free...
-
Responder a: MacBook will not boot but will chargeI found this pic for you, hope it helps: Won't power on even after replacing logic board.
-
Responder a: Why my iPhone 4 is overheating while using it?I would start with backing up the phone, then performing a full restore of the iOS. It could be corrupted software and this is, unfortunately, the least invasion step. If the overheating continues with just the iOS, inspect the dock connector and headphone jack liquid immersion sensors - if they are red/pink, then moisture has gotten into the unit. Use a flashlight to aid visualizing the sensors. In my experience, it takes _a lot_ to set them off in the iPhone4 - I had a coworker drop her's in the toilet, she fished it our immediately and got it to me fast. The sensors were still white, inside and out, then phone continued to function just fine after I disassembled and dried it out. If you can, don't restore your data from the backup yet - it is possible there is corruption in the data and leaving it off for a few hours can help with issue isolation. If the phone appears to be working properly with just iOS, then restore from backup (right-click on the iphone in the left column of iTunes for this option). If ...
Comentários do guia
Horas ativas
O período do dia em que você esteve ativo nos últimos 90 dias. Cada linha do gráfico é uma ação que você executou no site (só contamos ações importantes, como votação ou edição de postagens). Os números na parte inferior do gráfico são a hora do dia em horário MST.
Reputação ao longo do tempo
Discriminação da reputação
Evento | Contagem | Delta |
---|---|---|
Voto à favor da postagem | 263 | 3156 |
Resposta aprovada | 47 | 1410 |
Resposta Aceita | 1 | 10 |
Postagem marcada como não apropriada | 2 | -4 |
Marque um comentário como não apropriado | 4 | -8 |
Voto contra à postagem | 3 | -18 |
Votou negativo para o post | 19 | -38 |
Emblemas
96340
Notificações recentes
Marcar todas como lidas
Show:
Tudo
Tudo
Não lidas
Você está por dentro de tudo! Não há nenhuma notificação nova.
-
kurtz.a respondeu 'won't boot from floppy, get error 41 when boot from HD'
-
MatthewVArchuleta commented on your answer to "How dangerous is it to work on a CRT display?"
-
Free2go OurOwnWay commented on your answer to "How do I fix a sticky keyboard?"
-
Ardevas commented on your answer to "How dangerous is it to work on a CRT display?"
-
You were awarded the Boa resposta badge!
-
Elad Avron commented on your answer to "Tool to plug in to an ethernet jack to sense whether it is active"
-
slash dub commented on your answer to "Can I repair my broken keyboard ribbon retaining flap?"
-
You were awarded the Boa resposta badge!
-
Hey, David Iwanicki! Choose your unique username to improve your experience on ifixit!
-
stacyfrayer84 commented on your answer to "My ipod is locked and I forgot the password"
-
Darren Forster commented on your answer to "How dangerous is it to work on a CRT display?"
-
You were awarded the Boa resposta badge!
-
asle accepted your answer to 'Will not boot, grey screen'
-
Ayesha Qasim commented on your answer to "My ipod is locked and I forgot the password"
-
Robert Hayek commented on your answer to "My ipod is locked and I forgot the password"
-
You were awarded the Bela resposta badge!
-
You were awarded the Bela resposta badge!
-
You were awarded the Bela resposta badge!
-
You were awarded the Bela resposta badge!
-
You were awarded the Bela resposta badge!
-
You were awarded the Bela resposta badge!
-
You were awarded the Bela resposta badge!
-
You were awarded the Bela resposta badge!
-
You were awarded the Bela resposta badge!
-
You were awarded the Boa resposta badge!
-
Jaydan risner commented on your answer to "My ipod is locked and I forgot the password"
-
seamus commented on your answer to "How to take off a keyboard key ?"
-
Ski Bankowski commented on your answer to "How dangerous is it to work on a CRT display?"
W114 is similar, except clips are metal. On the coupe, there is also a small screw holding in the lock lever chrome surround (there is no lock stem type knob in the coupe).
the EMI fingers are VERY fragile...
the rear camera has an extra long tab which runs under the digitizer cable - be careful not to bend this while removing the camera.
watch for the connector cover here - it tends to be quite "springy" and may fly towards you when you attempt to release the clips
use the iPod opening tool to pry gently under the battery from the outer edge of the phone and work towards the plastic tab. the tab is not actually attached to the battery itself, but a plastic sheet between the battery and inner frame. the adhesive on the battery tends to be under the edge of the battery nearest the center of the phone.
this part is actually called the "top case", and is referenced as such in Apple's part numbers and take-apart guides.