Jim Thorpe

So, yeah. This step in particular is missing about three more steps, without which you are in danger of tearing the IR sensor. So here’s the missing info. After releasing the connectors from the board:

* remove the two Phillips screws, under the top lip of the phone chassis, holding the front camera assy in place.

* Pull the camera assy forward just enough to loosen the IR cable that lays across the board. No need to un-stick the ribbon cables from the chassis.

* use a spudger to disconnect the antenna cable from the board, directly under the IR cable.

* gently remove the laminate board while carefully pushing the ribbon connectors out of the way with a spudger.