trevor

hi. i have an iphone x that is stuck on error 6 when trying to restore it. it had a small drop and was stuck on the apple...

Hi. Just want to ask if NO SERVICE and SEARCHING on the iPhone 6 are the same fault? I have one that has no service. I did...

Hi, have an iPhone 6 that had a dark patch on the top right hand side of the display. The phone worked ok. I checked the...

hi, i have a 5c that wont charge a dead battery but will charge a battery that has power? i have change the charging chip...

hi, i have a sharp 32" tv that wont turn on. when you press power button on remote, the stand by light flashes blue 7...

hi. i have an iphone with a board fault. when using the keyboard the letters (y,g,h,b) dont work. i have tried a known...

hi. i have a 5s with an issue with the small camera not working. the phone had water damage near the fpc. i have tested...

Hi, I have a GeForce gtx780 video card that has a blown chip on it. There are two pairs of components I need to replace...

hi, i have an iphone 5 with a black display. i have tried a new screen, battery and tried the board in another phone but...

Hi, just wanted to know if I can upgrade the graphics card on Sony Vaio sve151d11m or add a graphics card externally?

have you tried using something like a needle to pry it back out? if that doesnt work you will need to remove the screen to access the buttons. you should watch a few youtube videos first to see if its something you want to try

have you checked at the back of the sim tray for any damaged components?

check to see if the storage memory is full.

i use oca adhesive sheets for all screen replacements. you need to cut it into strips to size but so far its the best solution i have found as it never lifts afterwards. its a bit tricky to work with but its worth the trouble. it bonds the digitizer to the frame very well and is thin enough so as not to leave the screen standing proud of the frame. i have also used b700 glue for frames with very thin edges to bond too. the oca is hard to work with when it needs to be cut very thin.

hope the schematics helped. did you know that the power/camera board can be got on its own. they can be found on ebay and are straight forward to replace. would save a lot of messing about. just make sure its the right one as i think there are two types.

the wifi antenna is held in place with adhesive and one screw. easy enough to remove. you do need to remove the vibrator as well because it shares a screw with the antenna.

when you enter it wrong it sould give you the option to reset by email. check the screen for an icon to reset

download itools english version. its a very user friendly program for idevices.

if its heating up then it could possibly have a short near the power ic. test for one with

you can get them on ebay