Meus guias
Guias para os quais contribuí
Respostas
-
Resposta para "How to determine Digitizer p/n"The digitizer part number is written on the digitizer's cable. If you have the wrong version, then you can update the digitizers firmware. These are the instructions from xda forums: 2. Root your device 2. Get the firmware https://github.com/dasunsrule32/prop...0... 3. Get it into the device: adb push 02-3011-4820.ekt /data/local/tmp 4. Get yourself into the device: adb shell su 5. Delete touch firmware. After firmware update and reboot the device may update the firmware back to whatever is in the firmware folder which is the wrong firmware. It will kill the ic ability to update the firmware again. <---HELP NEEDED In the shell: rm /system/etc/firmware/touch *.etk 6. Update firmware: touch_fw_update -u /data/local/tmp/02-3011-4820.ekt I used Kingo to get root on mine.
Comentários do guia
Reputação ao longo do tempo
Discriminação da reputação
Evento | Contagem | Delta |
---|---|---|
O administrador aprovou o seu guia | 5 | 492 |
Alguém completou seu guia | 16 | 333 |
Alguém curtiu seu guia | 11 | 54 |
Edição patrulhada de uma wiki aceita | 1 | 1 |
Votou negativo para o post | 2 | -4 |
Emblemas
535627
That sounds, to me, that you have an actual jam - that there is something in the road that is preventing the head from moving back and forth.
That lever’s job is to make the paper feed mechanism work the cleaning station. When the print head is way over to the right, it pushes that lever, which pushes a cog out to mesh with the paper feed rollers. Then, with the head in that position, the paper feed mech makes levers and wipers in the cleaning station work. Then, when the head moves away, the spring pushes the lever back, pulling that cog away from the paper feed mech, allowing it to move freely. When the spring breaks, the cheaning station stays connected to the paper feed mech, jamming it.
If the lever moves right, and returns left by itself without sticking, then your problem is elsewhere.
The part of the instructions that are a problem is testing with drops of water - The case of the phone might catch these drops and allow them inside the phone. Just don’t test it with drops of water and you’ll be fine.
I must say I don’t mind the tri-point screws. At these sizes, phillips screws are a real pain - like they aren’t at any size, think on - dropping to just three wings gives the screw a bit more meat.
But then again, I have a similar argument for pentalobe - that screw size is too small for torx or hex, Phillips is bad and wrong - pentalobe makes a nice, solid joint between screw and driver.