Este usuário ainda não preencheu o perfil.
Respostas
Do a hard reset on it. Heres How: Firstly, you need to quick-press the Volume Up button. That is, press it for a second or less and release it quickly. Without waiting anymore, quick-press the Volume Down button. Now, press and hold the Side button for at least 10 seconds. Keep pressing the Side button till the screen would vibrate. Let go of it once you see the Apple logo on the screen.
Saiba maisMy suggestion would be to replace the fuel filter. Maybe some sediment in the gas tank got sucked into the filter when you ran the vehicle on low fuel. This sounds like a textbook issue of a clogged fuel filter.
Saiba maisif you happened to be shooting in very cold weather, that’s likely why. When a Polaroid photograph is developing, several sequential chemical reactions are occurring in a perfectly timed fashion. At least that's the idea. When our film is in an extremely warm or cold environment, the chemical reactions are no longer occurring exactly when they were intended to. At colder temperatures chemical reaction rates slow down considerably. try taking pictures at room temp!
Saiba maisEither your front add motor is bad or the 4wd selector switch is blown.
Saiba maiscould be the LCD panel or the GPU. Connect an external monitor. If that show a good picture you know it is most likely your LCD panel that needs replacing. If the external monitor is showing the same issues, you have having problems with the GPU on the logic board and will have to at least disassemble your laptop to inspect. Hope this helps, good luck.
Saiba maisIt is Obsolete. However, Any 3rd party may carry it.
Saiba maishttps://www.youtube.com/watch?v=wYaKYwVU...
Saiba mais1. First turn off the tablet. 2. Next press and hold "Power" until you see the manufacturers logo on the screen, then release the power button. 3. "Quickly" press "Volume Down" and hold it for few seconds until you see the message "Safe mode: ON" or something similar. 4. If you wanted disable it, simply repeat the steps above, and you should see "Safe Mode: OFF" rather than on.
Saiba maisThere is not anything wrong with it. Check the float at the bottom of your dishwasher and make sure it is clear, if it is your dishwasher probably just needs a hard reset. Turn the breaker off for 4-5 minutes, after you turn it back on hold the cancel button down for 3-5 seconds. it will go through a drain cycle and then your dishwasher should be fine.
Saiba maisConnect the tablet to a wall power source using the wall charger and cable. Wait for about 10 minutes to ensure the tablet has gained enough power to start. Press and hold the “Volume Down” and “Power” buttons simultaneously for about 10 to 15 seconds..
Saiba maisPágina 1 de 2
Jessica
@jessica50728
253
Reputação
14
Soluções
0
Guias
Membro desde 09/06/19