Ir para o conteúdo principal

Riparare un Nintendo DS che non si carica

Inglês
Italiano

Traduzindo o passo 1

Passo 1
Repairing a Nintendo DS that is not charging: passo 0, imagem 1 %32
  • The EM10 charging filter is located next to the power connector on the motherboard.

  • If the filter is missing or obviously broken, move on to STEP 18

  • Use a multimeter to test the EM10 filter - measure the resistance between each of the yellow solder pads, and then between each of the cyan solder pads. If everything is OK you should have close to 0 Ohms between each set of pads. You should NOT have any connection between the cyan pads and yellow pads. If the filter fails either test it needs to be replaced.

Il filtro di ricarica EM10 si trova vicino al connettore di ricarica sulla scheda madre.

Se il filtro non è presente o palesemente rotto, passa direttamente allo STEP 18.

Usa un multimetro per testare il filtro EM10: misura la resistenza tra ciascuno dei pad di saldatura gialli e tra ciascuno dei pad di saldatura ciano. Se è tutto OK, dovresti avere quasi 0 Ohm tra ogni set di pad. NON dovresti avere alcun collegamento tra i pad ciano e i pad gialli. Se il filtro non supera uno dei due test, deve essere sostituito.

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.