Conserte seus objetos Comunidade Loja

MacBook Pro 15インチ Core 2 Duo （モデル番号A1226/A1260）の上側筐体交換

Aviso: Você está editando um guia tipo pré-requisito. Todas as alterações que você fizer afetarão todos os 43 guias que incluem este passo.

Voltar para o guia
Inglês
Japonês
Passo 6
MacBook Pro 15" Core 2 Duo Models A1226 and A1260 Upper Case Replacement: passo 0, imagem 1 %32 MacBook Pro 15" Core 2 Duo Models A1226 and A1260 Upper Case Replacement: passo 0, imagem 2 %32 MacBook Pro 15" Core 2 Duo Models A1226 and A1260 Upper Case Replacement: passo 0, imagem 3 %32

  • Do not yank the upper case off quickly. The case is attached to the logic board via a ribbon cable.

  • Lift up at the rear of the case and work your fingers along the sides, freeing the case as you go. Once you have freed the sides, you may need to rock the case up and down to free the front of the upper case.

  • There are four plastic clips above the DVD slot, and another above and to the left of the IR sensor. These clips can be very difficult to disengage without prying. They can also be difficult to re-engage during reassembly.

  • Reassembly Tip: Press down firmly on the tip of the top case above the location of each clip until you hear a snap to reseat them in their slots.

  • Reassembly Tip: The two center DVD clips will rarely snap back into place properly without help, and downward pressure will instead simply deform the frame around the DVD slot. Support the frame by inserting a plastic spudger into the DVD slot directly under the clip location until it is snug, then press down until you hear the snap.

上側筐体を急に引っ張り上げないでください。上側筐体はリボンケーブルでロジックボードに接続されています。

上側筐体のヒンジ側を持ち上げてから側面に指を当てて、順番にケースの固定を外して下さい。側面の固定を外し終わった後、手前側の固定を外すために上側筐体を上下に揺する必要があるかも知れません。

DVD挿入口の上には4つの樹脂製の爪があり、また赤外線レシーバーの上と左側にも爪があります。これらの爪をこじらずに外すのは大変に難しいです。また、組み付け直すのも難しくなっています。

組み立て直す際の注意： 爪がスロットに嵌る時のカチッという音が聞こえるまで、それぞれの爪がある場所の真上にある上側筐体の端をしっかり押し下げて下さい。

組み立て直す際の注意： DVD挿入口の上の中央2つの爪は対策なしで正しく嵌ることはほとんどなく、単純に筐体をまっすぐ押し下げると爪が嵌る代わりにDVD挿入口を変形させてしまう恐れがあります。樹脂製のスパッジャーなどをDVD挿入口の爪の真下部分ににぴったり合うように差し込んで支えてから、カチッという音が聞こえるまで上側筐体を押し下げて下さい。

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.