Pular para o conteúdo principal

Aviso: Você está editando um guia tipo pré-requisito. Quaisquer alterações que você faça afetarão todos os 22 guias que incluem este passo.

Inglês
Japonês
Passo 4
Disconnect the digitizer cable by prying it straight up from its socket on the logic board. When reconnecting the digitizer cable, do not press the center of the connector. Press one end of the connector, then press the opposite end. Pressing in the center of the connector can bend the component and cause digitizer damage.
  • Disconnect the digitizer cable by prying it straight up from its socket on the logic board.

  • When reconnecting the digitizer cable, do not press the center of the connector. Press one end of the connector, then press the opposite end. Pressing in the center of the connector can bend the component and cause digitizer damage.

スパッジャーの平面側先端や指の爪先を使って、基板上ソケットからデジタイザーケーブルをまっすぐ上に引き上げて接続を外します。

デジタイザケーブルを再接続する際は、コネクターの中央を押さないでください。コネクターの片一方を押し込んでから、反対側を押します。コネクターの中央を押すとコンポーネントが曲がり、デジタイザーにダメージを与えてしまいます。

[* black] Use the flat end of a spudger, or a fingernail, to disconnectDisconnect the digitizer cable by prying it straight up from its socket on the logic board.
[* black] Use the flat end of a spudger, or a fingernail, to disconnectDisconnect the digitizer cable by prying it straight up from its socket on the logic board.
[* icon_caution] When reconnecting the digitizer cable, '''do not press the center of the connector'''. Press one end of the connector, then press the opposite end. Pressing in the center of the connector can bend the component and cause digitizer damage.

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.