Conserte seus objetos Comunidade Loja

여는 절차

Aviso: Você está editando um guia tipo pré-requisito. Todas as alterações que você fizer afetarão todos os 19 guias que incluem este passo.

Voltar para o guia
Inglês
Coreano
Passo 17
Opening Procedure, Tip for removing EMI shields: passo 0, imagem 1 %32 Opening Procedure, Tip for removing EMI shields: passo 0, imagem 2 %32 Opening Procedure, Tip for removing EMI shields: passo 0, imagem 3 %32
Tip for removing EMI shields

  • Use this method to remove any EMI shields necessary during your repair:

  • Use one tip of a pair of angled tweezers to pry up the EMI shield from the gaps between the "teeth."

  • Repeat this procedure at different points around the perimeter of the shield until it is free.

  • Try not to deform the shields too much—you will need to reinstall them during reassembly.

  • To reinstall, correct any deformations to the best of your ability, make sure the "teeth" align with the rim on the motherboard, and press down on the entire perimeter of the EMI shield.

  • Make sure all "teeth" are snug to the metal rim and not bent underneath the EMI shield.

EMI 실드 분리 팁

이 방법을 사용하여 수리하는 동안 필요한 EMI 실드를 분리하세요하려면 이 방법을 사용하십시오:

각진 핀셋의 한쪽 끝을 사용하여 "teeth" 사이의 틈에서 EMI 실드를 들어 올리세요.

실드가 분리될 때까지 실드 주변의 다른 곳에도 이 절차를 반복하세요.

실드를 너무 많이 변형하지 마세요—재조립하는 동안 실드를 다시 설치해야 합니다.

다시 설치하려면 변형된 부분을 최대한 복원하여 "teeth"가 마더보드의 테두리와 정렬되는지 확인하고 EMI 실드의 전체 둘레를 아래로 눌러주세요.

모든 "teeth"가 금속 테두리에 꼭 맞고 EMI 실드 밑에서 구부러지지 않는지 확인하세요.

[title] Tip for removing EMI shields
[* icon_note] Use this method to remove any EMI shields necessary during your repair:
- [* black] Use one tip of a pair of angled tweezers to pry up the EMI shield from the gaps between the "teeth."
+ [* black] Use one tip of a pair of [product|IF145-020-5|angled tweezers] to pry up the EMI shield from the gaps between the "teeth."
[* black] Repeat this procedure at different points around the perimeter of the shield until it is free.
[* icon_caution] Try not to deform the shields too much—you will need to reinstall them during reassembly.
[* icon_reminder] To reinstall, correct any deformations to the best of your ability, make sure the "teeth" align with the rim on the motherboard, and press down on the entire perimeter of the EMI shield.
[* icon_caution] Make sure all "teeth" are snug to the metal rim and not bent underneath the EMI shield.

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.