Ir para o conteúdo principal

Sostituzione Pannello LCD e digitizer Nintendo Switch

Aviso: Você está editando um guia tipo pré-requisito. Todas as alterações que você fizer afetarão todos os 2 guias que incluem este passo.

Inglês
Italiano
Passo 2
Nintendo Switch LCD and Digitizer Separation: passo 0, imagem 1 %32 Nintendo Switch LCD and Digitizer Separation: passo 0, imagem 2 %32 Nintendo Switch LCD and Digitizer Separation: passo 0, imagem 3 %32
  • Turn the screen assembly over.

  • Insert an opening pick in between the LCD panel and the digitizer at the top-left corner.

  • It doesn't matter how deep you insert the opening pick, but about 5 mm is enough to slice through all the adhesive.

  • You can slightly bend the digitizer to create a wider gap, but take care not to bend it too far to cause damage to the digitizer if you're reusing it.

  • Slide the opening pick along the top edge of the screen assembly to slice the adhesive.

Gira il gruppo dello schermo a faccia in giù.

Infila un plettro tra il pannello LCD e il digitizer sotto l'angolo in alto a sinistra.

Non importa quanto infili a fondo il plettro, ma 5mm sono sufficienti per tagliare tutto l'adesivo.

Puoi piegare leggermente il digitizer per creare una fessura, ma stai attento a non piegarlo troppo se lo vuoi riutilizzare: potresti danneggiarlo.

Fai scorrere il plettro sotto il bordo superiore del gruppo dello schermo per tagliare l'adesivo.

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.