Ir para o conteúdo principal

Nintendo Switch LCD und Touchscreen trennen

Aviso: Você está editando um guia tipo pré-requisito. Todas as alterações que você fizer afetarão todos os 2 guias que incluem este passo.

Inglês
Alemão
Passo 2
Nintendo Switch LCD and Digitizer Separation: passo 0, imagem 1 %32 Nintendo Switch LCD and Digitizer Separation: passo 0, imagem 2 %32 Nintendo Switch LCD and Digitizer Separation: passo 0, imagem 3 %32
  • Turn the screen assembly over.

  • Insert an opening pick in between the LCD panel and the digitizer at the top-left corner.

  • It doesn't matter how deep you insert the opening pick, but about 5 mm is enough to slice through all the adhesive.

  • You can slightly bend the digitizer to create a wider gap, but take care not to bend it too far to cause damage to the digitizer if you're reusing it.

  • Slide the opening pick along the top edge of the screen assembly to slice the adhesive.

Drehe das Display herum.

Setze ein Plektrum in die obere linke Ecke zwischen LCD und Touchscreen.

Es spielt keine Rolle, wie tief du das Plektrum einschiebst, aber 5 mm reichen, um den Kleber komplett aufzuschneiden.

Um den Spalt zu vergrößern, kannst du den Touchscreen ganz leicht verbiegen, aber nicht so sehr, dass der Touchscreen beschädigt wird, besonders wenn du ihn wiederverwenden willst.

Schiebe das Plektrum zum Auftrennen des Klebers an der Oberkante des Displays entlang.

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.