Ir para o conteúdo principal

Desmontaje de Oculus Quest 2

Inglês
Espanhol
Passo 2
Oculus Quest 2 Disassembly, Remove the rear cover: passo 0, imagem 1 %32 Oculus Quest 2 Disassembly, Remove the rear cover: passo 0, imagem 2 %32
Remove the rear cover
  • One side at a time, insert a pick next to the nosepiece, slide it to the edge and pry.

  • When both sides are loose, carefully lift the cover out, and fold it so that the nose piece is on the outer perimeter of the device, as shown in the second image.

  • The proximity sensor is still connected via a flex cable, so be careful to not rip or crease the cable.

  • Lift the small black clip on the ZIF connecter up, and pull the flex cable out.

  • The cable is lightly adhered to the headset so be careful when removing it.

  • During reassembly, make sure to position the cable correctly. Latching the small black clip back on shouldn't require much force. If you don't connect the cable correctly, the headset's screen may stay black and the device will turn off after a few seconds.

Un lado a la vez, inserta una púa al lado de la boquilla, deslízala hacia el borde y haz palanca.

Cuando ambos lados estén sueltos, levante con cuidado la cubierta y dóblala de modo que la boquilla quede en el perímetro exterior del dispositivo, como se muestra en la segunda imagen.

El sensor de proximidad todavía está conectado a través de un cable flexible, así que ten cuidado de no rasgar o arrugar el cable.

Levanta el pequeño clip negro del conector ZIF y extrae el cable flexible.

El cable está ligeramente adherido al auricular, así que ten cuidado al retirarlo.

Durante el montaje, asegúrate de colocar el cable correctamente. Volver a enganchar el pequeño clip negro no debería requerir mucha fuerza. Si no conectas el cable correctamente, la pantalla de los auriculares puede permanecer en negro y el dispositivo se apagará después de unos segundos.

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.