Conserte seus objetos Comunidade Loja

후면 커버 분리

Aviso: Você está editando um guia tipo pré-requisito. Todas as alterações que você fizer afetarão todos os 14 guias que incluem este passo.

Voltar para o guia
Inglês
Coreano
Passo 7
Back Cover Removal: passo 0, imagem 1 %32 Back Cover Removal: passo 0, imagem 2 %32 Back Cover Removal: passo 0, imagem 3 %32

  • Be careful near the corners, as the glass is weakest there.

  • Insert an opening pick into the lower-left corner of the rear panel.

  • Using another opening pick, cut the adhesive along the left edge of the rear panel.

  • Don't insert an opening pick in more than halfway on the left edge near the fingerprint sensor or you may damage the ribbon cable inside.

  • It is fine if opening picks fall out as the back cover becomes separated.

후면 패널 왼편-하단 모서리에 여는 픽을 끼우세요.

다른 여는 픽을 사용하여 후면 패널의 왼편 가장자리를 따라 접착제를 자르세요.

지문 센서 근처 왼편 가장자리에 픽을 절반 이상 끼우지 마세요. 아니면 내부 리본 케이블을 손상할 수 있습니다.

후면 커버가 분리될 때 여는 픽은 빠져도 괜찮습니다.

+[* icon_caution] Be careful near the corners, as the glass is weakest there.
[* black] Insert an opening pick into the lower-left corner of the rear panel.
[* black] Using another opening pick, cut the adhesive along the left edge of the rear panel.
-[* icon_caution] Do not insert an opening pick in more than half way on the left edge near the fingerprint sensor or you may damage the ribbon cable inside.
+[* icon_caution] Don't insert an opening pick in more than halfway on the left edge near the fingerprint sensor or you may damage the ribbon cable inside.
[* icon_note] It is fine if opening picks fall out as the back cover becomes separated.

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.