Introdução

Connects the hard drive to the logic board.

Peças

Não são necessárias peças.

Before opening your iPod, ensure that the hold switch is in the locked position.
  • Before opening your iPod, ensure that the hold switch is in the locked position.

Adicionar comentário

Opening the iPod can be challenging. Don't get discouraged if it takes a few tries before the iPod is opened.
  • Opening the iPod can be challenging. Don't get discouraged if it takes a few tries before the iPod is opened.

  • Insert a plastic iPod opening tool in the seam between the white plastic front and metal back of the iPod. Once you've inserted the tool, run it along the seam to free the five tabs holding the iPod together.

Adicionar comentário

Continue to run the opening tool along the side of the case until all five tabs have been released.
  • Continue to run the opening tool along the side of the case until all five tabs have been released.

Adicionar comentário

Work around the corner of the iPod and release the two tabs holding the iPod together near the dock connector.
  • Work around the corner of the iPod and release the two tabs holding the iPod together near the dock connector.

Adicionar comentário

Free the five tabs holding the iPod together on the other side. You may be able to free the tabs by gently wiggling the front panel of the iPod.
  • Free the five tabs holding the iPod together on the other side. You may be able to free the tabs by gently wiggling the front panel of the iPod.

Adicionar comentário

Lift the rear panel away from the iPod, making sure it doesn't catch on the headphone jack.
  • Lift the rear panel away from the iPod, making sure it doesn't catch on the headphone jack.

Adicionar comentário

Peel up the metallic tape attached to the top of the battery.
  • Peel up the metallic tape attached to the top of the battery.

Adicionar comentário

Lift the battery up from the hard drive and lay it next the the iPod (it is still connected to the logic board).
  • Lift the battery up from the hard drive and lay it next the the iPod (it is still connected to the logic board).

Adicionar comentário

Carefully disconnect the orange ribbon cable from the hard drive.
  • Carefully disconnect the orange ribbon cable from the hard drive.

  • If the cable doesn't come free easily, it may be helpful to gently wiggle the cable from side to side.

  • Lift the hard drive out of the iPod.

Adicionar comentário

For the following step, you only need to move the locking bar about 2 mm. Pushing too hard or too far will damage the connector.
  • For the following step, you only need to move the locking bar about 2 mm. Pushing too hard or too far will damage the connector.

  • Loosen the connector by pulling the brown locking bar toward the hard drive cable using the tips of your fingers.

Adicionar comentário

Slide the hard drive cable out of its connector.
  • Slide the hard drive cable out of its connector.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

iRobot

Member since: 24-09-2009

1 reputação

750 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 2

Todo: 5,150