Ir para o conteúdo principal

iPhone 7 Plus Speaker Replacement

Pré-requisito somente
Este guia destina-se apenas a ser usado como pré-requisito para outros guias. É incompleto por si só.

O que você precisa

  1. iPhone 7 Plus Speaker Replacement, Speaker: passo 1, imagem 1 %32 iPhone 7 Plus Speaker Replacement, Speaker: passo 1, imagem 2 %32
    • Use a thin pry tool or tweezers to carefully pry up and disconnect the upper coaxial cable connector from the logic board.

    • There are two coaxial connectors in close proximity. Disconnect the one nearest the battery connector.

    • During reassembly, this can be tricky to reconnect. Hold the connector in place over its socket and press down with the flat of your spudger. The connector should snap into place.

  2. iPhone 7 Plus Speaker Replacement: passo 2, imagem 1 %32 iPhone 7 Plus Speaker Replacement: passo 2, imagem 2 %32
    • Carefully de-route the coaxial cable you just disconnected from the small metal clip holding it to the logic board.

  3. iPhone 7 Plus Speaker Replacement: passo 3, imagem 1 %32 iPhone 7 Plus Speaker Replacement: passo 3, imagem 2 %32
    • Use tweezers or the point of your spudger to pry both coaxial cables out of the metal clip holding them on the side of the speaker.

  4. iPhone 7 Plus Speaker Replacement: passo 4, imagem 1 %32
    • Remove the five Phillips screws securing the speaker:

    • Three 1.3 mm screws

    • One 2.3 mm screw

    • One 3.3 mm screw

  5. iPhone 7 Plus Speaker Replacement: passo 5, imagem 1 %32
Conclusão

To reassemble your device, follow these instructions in reverse order.

Jeff Suovanen

Membro desde: 08/06/13

428.104 Reputação

Autoria de 259 guias

Equipe

iFixit Membro de iFixit

Staff

Membros da 135

Autoria de 16.817 guias

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 44