Alterações no passo nº 4
Edição por Jeff Suovanen —
Edição aprovada por Jeff Suovanen
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* black] behold! blessed srews hiding under the rubber footses |
|---|---|
| - | [* black] And hecka long screws |
| - | [* black] Suction cup to remove the heavy bottom panel... almost (there's a speaker/woofer cable/connector holding it on, but we'll show that in the next step) |
| + | [* black] Time for a peek inside. Looking for a point of entry, we tip the Studio onto its back and inspect the base. |
| + | [* black] A subtle strip of air vents borders the entire bottom panel. At each corner, we find a round rubber foot. |
| + | [* black] Happily, each foot conceals a (long) Torx screw—we know what to do with those. |
| + | [* black] The heavy bottom cover doesn't pull away quite as easily as expected, so we apply a little [product|IF145-023|suction power|new_window=true]. |
| + | [* black] We're in! Almost. |