Conserte seus objetos Comunidade Loja

Alterações no passo nº 5

Edição por Arthur Shi —

Edição aprovada por Arthur Shi

Antes
Depois
Sem alteração

Linhas do passo

[* black] To complete your continuity test, place one probe at each end of the circuit or component you want to test.
-[* black] As before, if your circuit is continuous, the screen displays a value of zero (or near zero), and the multimeter ***beeps***.
-[* black] If the screen displays 1 or OL (open loop), there's no continuity—that is, there's no path for electric current to flow from one probe to the other.
+[* icon_note] As before, if your circuit is continuous, the screen displays a value of zero (or near zero), and the multimeter ***beeps***.
+[* icon_note] If the screen displays 1 or OL (open loop), there's no continuity—that is, there's no path for electric current to flow from one probe to the other.
[* icon_note] Continuity is non-directional, meaning it doesn't matter which probe goes where. But there are exceptions—for instance, if there's a diode in your circuit. A diode is like a one-way valve for electricity, meaning it will show continuity in one direction, but ''not'' in the other.
[* black] To check for this, reverse what the probes are touching and check for continuity. If the multimeter shows continuity, then it's possibly a diode.