Alterações no passo nº 6
Edição por Braeden —
Edição aprovada por Arthur Shi
- Antes
- Depois
- Sem alteração
Linhas do passo
| + | [title] Press Connectors |
|---|---|
| [* icon_note] Smaller press-fit (or "pop") connectors may require a simple flick with a plastic opening tool, spudger, or fingernail. | |
| [* black] Place the tip of your tool under the edge of the connector, and pry the connector straight up from its socket. | |
| [* icon_caution] Be very careful to pry ***only*** under the edge of the connector, and not under the socket itself. If you pry under the socket, you will separate it from the circuit board, which requires specialized microsoldering skills and equipment to repair. | |
| [* icon_reminder] To reconnect, align the connector carefully over its socket and press down with your fingertip—first at one side, then the other—until it clicks into place. | |
| [* icon_caution] ***Do not*** press down on the middle until the connector is fully seated—if it's misaligned, the connector can bend, causing permanent damage. |