Conserte seus objetos Comunidade Loja

Alterações no passo nº 6

Edição por Arthur Shi —

Edição aprovada por Arthur Shi

Antes
Depois
Sem alteração

Linhas do passo

-[* black] Move the heat shrink to the solder area; completely cover the area. Using a heat source (i.e.,grill lighter), begin heating the middle of the solder area and slowly move towards the end of the soldier to the insulation.
- [* black] The heat shrink acts as insulation for the wire.
-[* icon_note] The process should not exceed more than ten seconds.
+[* black] Slide the heat-shrink over the exposed solder joint so that it completely covers the joint and the surrounding insulation.
+ [* icon_note] The heat-shrink acts as insulation for the wire.
+[* black] Wave a heat source (lighter or heat gun) over the heat-shrink material to activate it. Apply heat until the heat-shrink has shrunk securely around the solder joint.