Alterações no passo nº 2
Edição por Craig Lloyd —
Edição aprovada por Craig Lloyd
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* black] Turn the screen assembly over. | |
| [* black] Insert an opening pick in between the LCD panel and the digitizer at the top-left corner. | |
| - | [* icon_note] You can slightly bend the digitizer to create a wider gap, but take care not to bend it too far to cause damage to the digitizer. |
| + | [* icon_note] It doesn't matter how deep you insert the opening pick, but about 5 mm is enough to slice through all the adhesive. |
| + | [* icon_note] You can slightly bend the digitizer to create a wider gap, but take care not to bend it too far to cause damage to the digitizer if you're reusing it. |
| [* black] Slide the opening pick along the top edge of the screen assembly to slice the adhesive. |