Alterações no passo nº 10
Edição por Craig Lloyd —
Edição aprovada por Craig Lloyd
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* icon_note] If your motherboard has a socket for a hard drive temperature sensor, follow this step to plug the sensor wires in. | |
| - | [* black] Find |
| + | [* black] Find the connector on the motherboard labeled ***HD TMP*** or ***HDD TEMP***. |
| [* icon_note] If you have trouble locating it, trace the two-wire temperature cable you disconnected from the old hard drive. | |
| [* black] If the previous temperature cable is still connected to the board here, disconnect and remove it. You will no longer need it. | |
| [* black] Connect the temperature sensor's two-wire red-black cable to the motherboard plug labeled ***HD TMP*** or ***HDD TEMP***. | |
| - | [* icon_note] The connector is keyed to fit in one |
| + | [* icon_note] The connector is keyed to fit in only one orientation. If it doesn't fit one way, rotate it 180° and try again. |
| [* black] Route the excess wire so it does not interfere with any other components. |