Alterações no passo nº 1
Edição por Claire Miesch —
Edição aprovada por Claire Miesch
- Antes
- Depois
- Sem alteração
Linhas do passo
| + | [title] Replace IC |
|---|---|
| + | [* black] On the main PCB with the power-jack, replace the MTX2410 switchmode regulator IC (SO-8 Package). |
| + | [* black] There is a pin-compatible device from Quorvo (ACT4060ASH-T) which has a different internal voltage reference but otherwise works fine. Only a resistor must be changed for this to work. |
| + | [* black] Feedback Voltage for MXT2410 is 1.222V, for ACT4060 is 1.293V, so voltage divider on Pin5 must be changed accordingly. |
| + | [* black] One can best adjust R4+R3 (series). Remove R4, measure R3 and R4, and increase. It should measure about 10.67kOhm (R3 plus R4), and it can be slightly increased to 11.51kOhm. So basically add 1kOhm to R3+R4. |
Imagem 1
Nenhuma imagem anterior
Adicionado