Histórico do passo nº 6 do guia How to Build a Waterproof Pressure Sensor

Alterações no passo nº 6

Edição por Ella Leininger — 26 de nov de 2019

Edição aprovada por Taylor Dixon

	[title] Attach Wires
-	[* black] A wire is necessary on the ground, SDA, SDO, SCK, CS, Vd and VdIO pins. These can be identified from the top of the board. Take a wire and strip 1/4 of an inch of insulation off one end, insert it into the through hole, and solder it into place. (Tip: consider which way you want your wires to run). Repeat for all seven wires.
+	[* black] A wire is necessary on the ground, SDA, SDO, SCK, CS, Vd and VdIO pins. These can be identified from the top of the board.
+	[* black] Take a wire and strip 1/4 of an inch of insulation off one end, insert it into the through hole, and solder it into place.
+	[* black] Repeat for all seven wires.
+	[* icon_note] Tip: consider which way you want your wires to run. You can solder them on either side of the board.