Conserte seus objetos Comunidade Loja

Alterações no passo nº 6

Edição por Ella Leininger —

Edição aprovada por Taylor Dixon

Antes
Depois
Sem alteração

Linhas do passo

[title] Attach Wires
-[* black] A wire is necessary on the ground, SDA, SDO, SCK, CS, Vd and VdIO pins. These can be identified from the top of the board and with the sensor's datasheet. Take a wire and strip 1/4 of an inch of insulation off one end, insert it into the through hole, and solder it into place. Repeat for all seven wires.
+[* black] A wire is necessary on the ground, SDA, SDO, SCK, CS, Vd and VdIO pins. These can be identified from the top of the board. Take a wire and strip 1/4 of an inch of insulation off one end, insert it into the through hole, and solder it into place. (Tip: consider which way you want your wires to run). Repeat for all seven wires.