Alterações no passo nº 2
Edição por Ella Leininger —
Edição aprovada por Taylor Dixon
- Antes
- Depois
- Sem alteração
Linhas do passo
| [title] Cut Pins | |
| - | [* black] The first step is to remove the pins, allowing for the wires to be soldered in. The easiest way to start this is to cut the pins one at a time between the black plastic and the PCB board, or along the red line marked in the photo. Once you have clipped along the red line, then clip vertically along the blue line. |
| + | [* black] First, the pins must be removed allowing for the wires to be soldered in. |
| + | [* red] To do so, first cut along the red line in the photo to separate the pin from the board. |
| + | [* blue] Next, clip vertically along the blue line to disconnect the pin from the one next to it. |
| + | [* icon_caution] Be very careful while cutting to not damage the board! Rough handling can rip out the metal pads of the through holes ruining the board. |