Conserte seus objetos Comunidade Loja

Alterações no passo nº 1

Edição por Taylor Dixon —

Edição aprovada por Taylor Dixon

Antes
Depois
Sem alteração

Linhas do passo

-[* black] Remove the four 11 mm hex bolts holding the motor in place from the bottom of the frame assembly.
-[* icon_caution] Only remove these bolts while the pressure washer is in an upright position.
-[* black] The bolts have nuts on top
+[* black] Use a socket wrench to remove the four 11 mm hex bolts holding the motor in place from the bottom of the frame assembly.
+ [* icon_caution] Only remove these bolts while the pressure washer is in an upright position.
+ [* icon_note] You will likely need an additional 11 mm wrench to hold the nuts on top of the stacks in place as you loosen the bolts.