Alterações no passo nº 4
Edição por Jeff Suovanen —
Edição aprovada por Jeff Suovanen
- Antes
- Depois
- Sem alteração
Linhas do passo
| [* icon_note] Once the adhesive sticks to the battery, you can't peel it off or reposition it—if you make a mistake, you'll have to start over with fresh adhesive strips. | |
| - | [* black] Double-check the orientation of the adhesive strips, and then stick them to the ***back*** side of your new battery as shown. |
| - | [* icon_reminder] The black pull tabs at each end should protrude evenly over the edges of the battery. |
| + | [* black] Double-check the orientation of the adhesive strips, and make sure your battery is still lying face-down (with the connector contacts facing up). |
| + | [* black] Carefully position the adhesive strips over the battery, and stick them in place as shown. |
| + | [* icon_reminder] Place the strips slightly off-center, very close to the long edge of the battery. |
| + | [* icon_reminder] The black pull tabs at each end should protrude equally far over the top and bottom edges of the battery. |