Conserte seus objetos Comunidade Loja

Alterações no passo nº 2

Edição por Jeff Suovanen —

Edição aprovada por Jeff Suovanen

Antes
Depois
Sem alteração

Linhas do passo

-[* black] Insert an Opening Pick into the bottom edge of the back panel (opposite the L and ZL buttons).
-[* black] Slowly slide the flat edge of your Opening Pick up the side of the Joy-Con.
-[* icon_note] Be careful not to slide the Opening Pick too far inside the Joy-Con. This may damage the inner components. The back panel loosens fairly easily, so not much pressure is needed.
+[* black] Insert an opening pick into the seam at the bottom edge of the controller (opposite the L and ZL buttons).
+[* black] Slowly slide the flat edge of your opening pick up the side of the Joy-Con.
+ [* icon_note] Be careful not to slide the opening pick too far inside the Joy-Con. This may damage the inner components. The back panel loosens fairly easily, so not much pressure is needed.