Conserte seus objetos Comunidade Loja

Histórico da introdução: How to Use the VoltClip to Debond iPhone Battery Adhesive

Edição por Arthur Shi —

Edição aprovada por Arthur Shi

Antes
Depois
Sem alteração
Dispositivo
Electronics Skills
Type
technique
Title
How to Use the VoltClip to Debond an iPhone Battery Adhesive
Introduction
This guide shows how to use the VoltClip to loosen electrical debonding-on-demand adhesives. Currently, iPhone 16 and 16 Plus batteries use this type of adhesive.
Electrical debonding-on-demand works by passing [link|https://www.ifixit.com/News/100352/we-hot-wired-the-iphone-16|low electrical current through the adhesive|new_window=true]. A 9-30 volt DC source is connected across the adhesive, and the resulting electrochemical reaction loosens the adhesive bond in minutes.
***The VoltClip requires a USB-C Power Delivery (PD) power source***. This can either be the [product|IF145-494|FixHub Portable Power Station|new_window=true], a [product|IF145-542|USB-C PD power brick|new_window=true], or some laptops/smartphones.
''Not all USB-C PD power sources support 12 V'' (the FixHub Portable Power Station does). If the source doesn't support 12 V, the VoltClip will output at the next lowest voltage—usually 9 V. This voltage is still sufficient to debond the adhesive.
Time Required Min
Nenhuma estimativa
Time Required Max
Nenhuma estimativa
Difficulty
Moderate
Conclusion
To reassemble your device, follow these instructions in reverse order.
Author
Arthur Shi
Public
Não

Sinalizadores

  • In Progress added.

Passos

Passo nº: 1
Antes
Depois
stepid 378018 stepid 378018