Conserte seus objetos Comunidade Loja

Wire Stripping

Introdução

Wire needs to be exposed from its insulation in order before it can be soldered to another wire. Wire stripping exposes the wire so you are able to make good connections.

O que você precisa

  1. Wire Stripping, Wire Stripping: passo 1, imagem 1 %32

    • Match your gauge of wire to the gauge on a wire stripper.

    • Some wire strippers will have two gauge sizes for the same hole, one for solid wire and one for stranded. Make sure you use the right one for the wire you are stripping!

    Editar

  3. Wire Stripping: passo 2, imagem 1 %32

    • Place the wire stripper about a 1/4” from the end of the wire and squeeze down.

    • You can strip more than 1/4" at a time, but the effort becomes harder. About 1/2-5/8" (13-16 mm) is the most you should probably attempt.

    Editar

  4. Wire Stripping: passo 3, imagem 1 %32

    • While squeezing, pull the stripper toward the end of the wire. This should expose some of the wire by removing its insulation.

    Editar
Conclusão

After your wire has been stripped, the exposed wire is ready to be soldered and reconnected to other parts of the microphone.

17 outras pessoas executaram este guia.

Autor(a)

com 9 outros contribuidores

nat coll

Membro desde: 09/27/12

790 Reputação

Autoria de 14 guias

Emblemas: 13

+10 outros emblemas

Equipe

Cal Poly, Team 7-53, Forte Fall 2012 Membro de Cal Poly, Team 7-53, Forte Fall 2012

CPSU-FORTE-F12S7G53

5 Membros

Autoria de 33 guias

0Comentários do guia

Comentar

Visualizações:

Últimas 24 horas: 16

Últimos 7 dias: 134

Últimos 30 dias: 466

Ao todo: 9,835