Conserte seus objetos Comunidade Loja

Vtech Kidizoom Smart Watch DX Battery Replacement

Introdução

Battery dead, or not holding a charge? Follow this guide to replace it with a new one! Note: This guide requires soldering.

O que você precisa

  1. Vtech Kidizoom Smart Watch DX Battery Replacement, Master Switch: passo 1, imagem 1 %32

    • Make sure the master switch is "OFF" before disassembly, to avoid an electric shock.

    • Flip the watch over with the back facing up.

    Editar

  2. Vtech Kidizoom Smart Watch DX Battery Replacement: passo 2, imagem 1 %32

    • Remove the four 6.0 mm screws on the back plate with the Phillips #00 screwdriver.

    Editar

  3. Vtech Kidizoom Smart Watch DX Battery Replacement: passo 3, imagem 1 %32

    • Gently pull the back plate from the watch casing.

    Editar

  4. Vtech Kidizoom Smart Watch DX Battery Replacement: passo 4, imagem 1 %32 Vtech Kidizoom Smart Watch DX Battery Replacement: passo 4, imagem 2 %32

    • Lift the master switch from the circuit board.

    Editar

  5. Vtech Kidizoom Smart Watch DX Battery Replacement, Circuit Board: passo 5, imagem 1 %32 Vtech Kidizoom Smart Watch DX Battery Replacement, Circuit Board: passo 5, imagem 2 %32

    • The speaker wires are fragile. They may break if excessive force is used to remove the circuit board.

    • Removal of the circuit board requires soldering.

    • Gently push on the display from the front, near the camera. The circuit board and display will pop out through the back.

    Editar

  7. Vtech Kidizoom Smart Watch DX Battery Replacement: passo 6, imagem 1 %32

    • Lift the circuit board carefully from the casing, without breaking or detaching the speaker wires at the bottom of the circuit board.

    Editar

  8. Vtech Kidizoom Smart Watch DX Battery Replacement: passo 7, imagem 1 %32

    • Note which wire is connected to which lead before continuing. There are no markers on the circuit board to indicate where each wire belongs.

    • De-solder the black speaker wire from the circuit board.

    Editar

  9. Vtech Kidizoom Smart Watch DX Battery Replacement: passo 8, imagem 1 %32

    • De-solder the red speaker wire, as in the previous step.

    Editar

  10. Vtech Kidizoom Smart Watch DX Battery Replacement: passo 9, imagem 1 %32

    • Wait for the solder to cool down and solidify, then remove the circuit board from the casing.

    Editar

  11. Vtech Kidizoom Smart Watch DX Battery Replacement, Battery: passo 10, imagem 1 %32 Vtech Kidizoom Smart Watch DX Battery Replacement, Battery: passo 10, imagem 2 %32

    • Using the plastic opening tool, gently pry the edges of the battery away from from the circuit board.

    • There is a thin layer of adhesive holding the battery to the circuit board. This will remain sticky after prying.

    Editar

  12. Vtech Kidizoom Smart Watch DX Battery Replacement: passo 11, imagem 1 %32

    • De-solder the red battery wire from the circuit board.

    Editar

  13. Vtech Kidizoom Smart Watch DX Battery Replacement: passo 12, imagem 1 %32

    • Repeat the de-soldering for the black (ground) wire.

    Editar

  14. Vtech Kidizoom Smart Watch DX Battery Replacement: passo 13, imagem 1 %32

    • Pull the battery free, and wait for the solder to cool before handling further.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

4 outras pessoas executaram este guia.

Autor(a)

com 2 outros contribuidores

Navin Ramkishun

Membro desde: 01/20/16

259 Reputação

Autoria de 1 guia

Emblemas: 9

+6 outros emblemas

Equipe

USF Tampa, Team 10-6, Remmell Spring 2016 Membro de USF Tampa, Team 10-6, Remmell Spring 2016

USFT-REMMELL-S16S10G6

Membros da 4

Autoria de 12 guias

Um comentário

Where did you bought the battery?

funkysoulbrother - Responder

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 2

Últimos 7 dias: 6

Últimos 30 dias: 40

Duração total: 8,992