Conserte seus objetos Comunidade Loja

Sony DualSense Controller L1 and R1 Button Replacement

Introdução

Follow this guide to replace the L1 and R1 trigger buttons on a Sony PlayStation 5 DualSense controller.

Disconnect and power down your controller before starting your repair.

O que você precisa

  1. Sony DualSense Controller L1 and R1 Button Replacement, Remove the L1 button: passo 1, imagem 1 %32 Sony DualSense Controller L1 and R1 Button Replacement, Remove the L1 button: passo 1, imagem 2 %32 Sony DualSense Controller L1 and R1 Button Replacement, Remove the L1 button: passo 1, imagem 3 %32

    • Insert the flat end of a spudger into the gap above the L1 button.

    • Cover the button with your thumb to prevent it from ejecting across the room.

    • Pry upward to remove the L1 button.

    Editar

  3. Sony DualSense Controller L1 and R1 Button Replacement, Remove the R1 button: passo 2, imagem 1 %32 Sony DualSense Controller L1 and R1 Button Replacement, Remove the R1 button: passo 2, imagem 2 %32 Sony DualSense Controller L1 and R1 Button Replacement, Remove the R1 button: passo 2, imagem 3 %32

    • Insert the flat end of a spudger into the gap above the R1 button.

    • Cover the button with your thumb to prevent it from ejecting across the room.

    • Pry upward to remove the R1 button.

    Editar
Conclusão

To reassemble your device, follow the above steps in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

3 outras pessoas executaram este guia.

Autor(a)

com 1 outro contribuidor

Sam Omiotek

Membro desde: 02/25/19

72.547 Reputação

Autoria de 288 guias

Emblemas: 35

+32 outros emblemas

3 comentários

It is easier to remove L1/R1 by going from below than by from above- without any damages.

Grim Of Doom - Responder

Does the spudger dent or mark the button when doing this?

Rory Bedell - Responder

My replacement R1 button is different enough to not fit. Fins around center sleeve are wider. So there must have been a design change at some point.

Walt Mather - Responder

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 24

Últimos 7 dias: 194

Últimos 30 dias: 901

Duração total: 19,325