Pular para o conteúdo principal

Introdução

The LED's, of the Solio Rocsta, are important to convey information. If your LEDs are burnt out, and no longer displaying light, we will show you how to replace them in this guide.

Please note that this guide requires soldering. For more information on how to solder and desolder connections, please visit this guide.

  1. Locate, and unscrew, the three 5.72 mm screws that hold down the top cover using the T6 Torx screwdriver. Locate, and unscrew, the three 5.72 mm screws that hold down the top cover using the T6 Torx screwdriver.
    • Locate, and unscrew, the three 5.72 mm screws that hold down the top cover using the T6 Torx screwdriver.

  2. Remove top cover. Caution: the solar cell is attached to the top cover and connected to the circuit board by a short wire .
    • Remove top cover.

    • Caution: the solar cell is attached to the top cover and connected to the circuit board by a short wire .

  3. Using the spudger, pry the battery off the back cover.
    • Using the spudger, pry the battery off the back cover.

  4. Kit de Reparo de Bateria do MacBook

    A partir de $69.99

    Buy Now

    Kit de Reparo de Bateria do MacBook

    A partir de $69.99

    Buy Now
  5. Using a T6 Torx screwdriver, unscrew the 5.66 mm screws attaching the circuit board to the case and flip the circuit board.
    • Using a T6 Torx screwdriver, unscrew the 5.66 mm screws attaching the circuit board to the case and flip the circuit board.

  6. With the circuit board flipped, locate the battery connector.
    • With the circuit board flipped, locate the battery connector.

    • Hold the component attached to the circuit board the battery is connected to and wiggle the cable out.

  7. Using a T6 Torx screwdriver, unscrew the 5.66 mm screws attaching the circuit board to the case.
    • Using a T6 Torx screwdriver, unscrew the 5.66 mm screws attaching the circuit board to the case.

  8. Flip the circuit board to be able to see where the LEDs are soldered to.
    • Flip the circuit board to be able to see where the LEDs are soldered to.

    • With a Soldering Iron, desolder the LEDs’ connectors.

    • For more information on how to solder and desolder connections, please visit this guide.

  9. Gently pry the LEDs using one of the Precision Tweezers.
    • Gently pry the LEDs using one of the Precision Tweezers.

Conclusão

To reassemble your device, follow these instructions in reverse order.

David Vazquez

Membro desde: 10-10-2017

529 reputação

5 Guias de autoria

Equipe

USF Tampa, Team S13-G13, Cagle Fall 2017 Membro de USF Tampa, Team S13-G13, Cagle Fall 2017

USFT-CAGLE-F17S13G13

4 Membros

6 Guias de autoria

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 1

Últimos 30 dias: 1

Todo: 56