Introdução

Buttons might tear and get worn out so it is important to replace the buttons.

Peças

Não são necessárias peças.

  1. Wedge a plastic opening tool in between the case.
    • Wedge a plastic opening tool in between the case.

    Adicionar comentário

  2. Starting with the bottom left corner, press down on the plastic opening tool to unhook the latches on the inside of the device.
    • Starting with the bottom left corner, press down on the plastic opening tool to unhook the latches on the inside of the device.

    • You have to start with the bottom left and right corners, and then flip the device to over and do the top of the device.

    Adicionar comentário

    • Once unclipped, separate the back casing from the device.

    Adicionar comentário

    • Remove the three 5mm JIS #00 screws from the motherboard.

    Adicionar comentário

    • Unlatch the two clips that hold the motherboard in place.

    Adicionar comentário

    • Lift the motherboard up and out of the frame.

    Adicionar comentário

    • Holding the front casing in your hand, push the button panels out of the casing.

    • There are two buttons panels: Navigation panel and the Channel Number panel

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Angel Rivera

Member since: 25-01-2018

505 reputação

5 Guides authored

Equipe

USF Tampa, Team S7-G2, Passmore Spring 2018 Membro de USF Tampa, Team S7-G2, Passmore Spring 2018

USFT-PASSMORE-S18S7G2

4 Membros

5 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 5

Todo: 35