Introdução

The faceplate connects all of the internal wiring of the microphone. If it is defective (or wires need to be reattached to it), this guide shows how to replace it.

Peças

Não são necessárias peças.

Remove the yellow and green wires from the face plate.
  • Remove the yellow and green wires from the face plate.

  • Note which side the yellow and green wires connect to.

Why should I replace the plate?

Gerrit - Responder

This guide was done as part of the capsule replacement—I don’t think there is any reason to solely replace the plate unless there was corrosion on it.

Daniel Berger - Responder

Never open the microphone capsule. Attempting to open the capsule will likely result in permanent damage and make the microphone unusable. Using an adjustable crescent wrench, remove the nut and washer from the face plate by twisting the nut counterclockwise.
  • Never open the microphone capsule. Attempting to open the capsule will likely result in permanent damage and make the microphone unusable.

  • Using an adjustable crescent wrench, remove the nut and washer from the face plate by twisting the nut counterclockwise.

Adicionar comentário

Slide the face plate over the connector. Slide the face plate over the connector.
  • Slide the face plate over the connector.

Adicionar comentário

Conclusão

Follow the steps of the guide in reverse to reassemble the microphone. In order to solder wires back to faceplate use soldering guide.

nat coll

Member since: 27-09-2012

366 reputação

17 Guides authored

Equipe

Cal Poly, Team 7-53, Forte Fall 2012 Membro de Cal Poly, Team 7-53, Forte Fall 2012

CPSU-FORTE-F12S7G53

5 Membros

18 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 9

Últimos 30 dias: 53

Todo: 5,416