Introdução

All of the internal wiring needs to be connected. Soldering wires to the Faceplate ensures that your microphone will function properly.

Peças

Não são necessárias peças.

Grab the microphone base with one hand. With the other hand, grab just below the grille (the collar). Twist the collar clockwise to loosen it. Be careful to not pull on the collar or you may rip the wires from the faceplate. Be careful to not pull on the collar or you may rip the wires from the faceplate.
  • Grab the microphone base with one hand. With the other hand, grab just below the grille (the collar). Twist the collar clockwise to loosen it.

  • Be careful to not pull on the collar or you may rip the wires from the faceplate.

Adicionar comentário

Plug the soldering iron in and let it heat up for five minutes. Plug the soldering iron in and let it heat up for five minutes.
  • Plug the soldering iron in and let it heat up for five minutes.

Adicionar comentário

If metal is not exposed from wire insulation, strip the broken wire. See wire stripping guide.

Adicionar comentário

Bend the wire around the contact point.
  • Bend the wire around the contact point.

  • The yellow wire goes to the contact above the red lettering.

  • The green wire goes on the contact point with a “+” next to it.

Adicionar comentário

In one hand, hold the solder. In the other hold your soldering iron.
  • In one hand, hold the solder. In the other hold your soldering iron.

  • Touch both the soldering iron and the solder to the contact point. The solder should melt and forge a connection to the face plate.

Adicionar comentário

First, remove the solder and then the soldering iron from the contact point.
  • First, remove the solder and then the soldering iron from the contact point.

  • If you remove the soldering iron first, the solder may become stuck to the contact point.

  • Let the wire cool for 30 seconds or so.

Adicionar comentário

If your wire is not completely connected, repeat steps 2-5 until the wire is reconnected.
  • If your wire is not completely connected, repeat steps 2-5 until the wire is reconnected.

Adicionar comentário

Conclusão

After soldering, all of your wiring should be connected to the Faceplate inside of the microphone.

4 outras pessoas concluíram este guia.

nat coll

Member since: 27-09-2012

366 reputação

17 Guides authored

Equipe

Cal Poly, Team 7-53, Forte Fall 2012 Membro de Cal Poly, Team 7-53, Forte Fall 2012

CPSU-FORTE-F12S7G53

5 Membros

18 Guides authored

I just want to say Thank you! Simple complete instruction. Couldn't be easier.

Steve Segura - Responder

I don't have a + on my plate, but several marks like one resembling Z, another one BB overlapped by 82 and A in the corner. Also I have 3 connection points (middle one is perhaps the black wire?), and 2 pairs of yellows and greens. Since I have version with switch, I suspect one pair of yellow and green being direct bypasses of the mic (you can see it coming from deeper in the body, while the other pair coming straight from the switch connection points).

In any case, how do I find out which colour for which connection point?

zetninetynine - Responder

I couldn't tell you without looking at the mic, however I am sure you could find the answer by googling it and reading through forums. What exactly are you trying to do to the mic?

Daniel Berger -

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 2

Últimos 7 dias: 41

Últimos 30 dias: 207

Todo: 12,738