Pular para o conteúdo principal

Introdução

Use this guide to remove or replace the case.

Peças

Nenhum componente especificado.

  1. Place your thumb on the right side of the camera over the battery door.
    • Place your thumb on the right side of the camera over the battery door.

    • Slide the battery door to the right until the door lifts up.

  2. Remove and recycle old batteries.
    • Remove and recycle old batteries.

  3. Unscrew 6 Phillips screws using the #00 Phillips screwdriver. Two screws are on the left side of the camera. Two screws are on the right side of the camera.
    • Unscrew 6 Phillips screws using the #00 Phillips screwdriver.

    • Two screws are on the left side of the camera.

    • Two screws are on the right side of the camera.

    • Two screws are on the bottom of the camera.

  4. Kit de Reparo de Bateria do MacBook

    A partir de $69.99

    Buy Now

    Kit de Reparo de Bateria do MacBook

    A partir de $69.99

    Buy Now
  5. Open battery slot on the bottom of the camera by sliding the door to the right. Remove the 4 mm phillips screw on the bottom right using the #00 phillips screwdriver.
    • Open battery slot on the bottom of the camera by sliding the door to the right.

    • Remove the 4 mm phillips screw on the bottom right using the #00 phillips screwdriver.

  6. Insert spudger in the seam at the bottom of the camera. Gently separate the rear case from the front of the camera. Gently separate the rear case from the front of the camera.
    • Insert spudger in the seam at the bottom of the camera.

    • Gently separate the rear case from the front of the camera.

  7. This step is only needed for the case and logic board replacement
    • This step is only needed for the case and logic board replacement

    • Using the #00 phillips screwdriver remove the screw attached to the front casing in the top left corner. Front case should easily separate.

  8. This step is only needed for the case replacement.
    • This step is only needed for the case replacement.

    • Using the #00 phillips screwdriver remove the screw on the inside of the battery door.

    • Slide the battery door off of the hinge.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Ariana Martinez

Membro desde: 15-04-2010

50 reputação

4 Guias de autoria

Equipe

Cal Poly, Team 24-24, Regan Spring 2010 Membro de Cal Poly, Team 24-24, Regan Spring 2010

CPSU-REGAN-S10S24G24

4 Membros

6 Guias de autoria

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Todo: 1,776