Peças

Não são necessárias peças.

  1. Apply pressure to the back cover and slide it forward towards the camera.
    • Apply pressure to the back cover and slide it forward towards the camera.

    • Lift the back cover off the phone.

    Adicionar comentário

  2. Holding the phone firmly, use the notches to grip and lift up the battery.
    • Holding the phone firmly, use the notches to grip and lift up the battery.

    Adicionar comentário

    • Remove the four 4.45mm screws at the corners of the phone.

    Adicionar comentário

    • Use the plastic opening tool to unhinge the locks around the edges of the phone.

    • Do not worry about the inner components of the phone; they are not connected to this case.

    Adicionar comentário

    • Lift the casing off of the phone.

    Adicionar comentário

    • With the screws removed, locate the antenna.

    Adicionar comentário

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Using a Phillips head screwdriver, remove the 4.50mm screw holding the antenna in place.

    Adicionar comentário

    • Using the plastic opener tool, squeeze gently on the antenna cable connector and lift to remove the connector from its position.

    Adicionar comentário

    • Gently lift up on the antenna and remove it from the back of the device.

    Adicionar comentário

    • Remove the two 3.50mm screws connecting the motherboard to the case.

    Adicionar comentário

    • Use the plastic opener tool to detach the three ribbons on the motherboard.

    Adicionar comentário

    • Lift out the top right ribbon from its slot on the motherboard.

    Adicionar comentário

    • Use the plastic opener tool to unhinge the the locks on the side of the motherboard connecting it to the front casing.

    Adicionar comentário

    • Lift the motherboard away from the front casing.

    Adicionar comentário

    • After removing lifting up on the motherboard, the front casing and center frame should be separated as shown.

    Adicionar comentário

    • Using the plastic opener tool, detach the ribbon located on the bottom of the phone below the battery compartment.

    Adicionar comentário

    • Lift the microchip (located at the bottom of the phone) and insert the plastic opener tool under the screen.

    • Lift up the screen. The microchip is attached to the screen and will be lifted out with the screen.

    Adicionar comentário

    • After lifting out the LCD screen, the screen and its housing should be separated as shown.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Patrick

Member since: 11-10-2011

60 reputação

2 Guides authored

Equipe

Cal Poly, Team 3-13, Regan Fall 2011 Membro de Cal Poly, Team 3-13, Regan Fall 2011

CPSU-REGAN-F11S3G13

4 Membros

16 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 3

Todo: 1,335