Introdução

If your battery is not working you can remove it and replace it following the step by step process. The battery can easily just pop out following simple steps

Peças

Não são necessárias peças.

  1. Turn the device over so that the screen is facing down.
    • Turn the device over so that the screen is facing down.

    • In the next step the device will be heated, so the screen must be turned over to prevent heat damage to the LCD/Digitizer.

    Adicionar comentário

  2. Using a hair dryer, slowly heat the edges of the WorkPad.
    • Using a hair dryer, slowly heat the edges of the WorkPad.

    • Spend at least one minute heating each side of the device. This will melt the glue holding the case together, and allow it to be removed.

    • Be sure not to touch the device directly after heating as it will be extremely hot. Use a towel or oven mitt to grab it.

    Adicionar comentário

    • Use a plastic opening tool to pry the back case from the WorkPad.

    • If the rear cover is not coming off very easily, you probably need to reheat the case in order to sufficiently melt the glue.

    Adicionar comentário

    • Remove the yellow tape that is covering the battery connector

    Adicionar comentário

    • Using the tweezers, carefully disconnect the battery cable from the port

    Adicionar comentário

    • Using the plastic opening tools, lift the battery out of the case

    • The battery is secured with adhesive and it will take some effort to remove

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Emily Falkenstein

Member since: 05-10-2010

51 reputação

5 Guides authored

Equipe

Cal Poly, Team 21-35, Regan Fall 2010 Membro de Cal Poly, Team 21-35, Regan Fall 2010

CPSU-REGAN-F10S21G35

3 Membros

5 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 3

Últimos 30 dias: 16

Todo: 3,437