PowerLead Puto PLD003 Back Buttons Replacement

Participe da comunidade de reparos - Criar conta

Introdução

This guide shows how to remove the screws that hold the camera together, how to remove the side panel from the camera, how to remove the back panel, and how to replace the back buttons.

O que você precisa

1. Passo 1 Side Panel
  Slide the battery eject button open to release the battery door.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
2. Passo 2
  With the battery door open, carefully remove all four 5 mm Phillips #1 screws.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
3. Passo 3
  Rotate the camera so that the underside is facing up.
  
  Remove the four 5 mm Phillips #1 screws.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
5. Passo 4
  Place the camera on a flat surface, with its underside facing you.
  
  Gently pull up on the side panel to remove it from the camera.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
1. Passo 5 Back Buttons
  Remove the three 4 mm Phillips #1 screws holding the weight.
  
  Remove the weight.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
2. Passo 6
  Remove the two 4 mm Phillips #1 screws holding the back panel in place.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
3. Passo 7
  Apply pressure to the back panel, away from the camera to remove.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
4. Passo 8
  Place the back panel so the buttons are facing down and the circuit board is facing up.
  
  Remove the three 4 mm Phillips #1 screws holding the circuit board in place.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
5. Passo 9
  Set aside the circuit board.
  
  These nubs are what is currently holding the buttons in place.
  
  Carefully apply pressure and remove the set of buttons from the nubs.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024