Conserte seus objetos Comunidade Loja

PowerA Spectra Contoller D-Pad Replacement

Introdução

This guide includes instructions on how to remove and replace the D-Pad button from the PowerA Spectra controller.

The D-Pad is a plus-symbol-shaped button that allows for four different inputs. The button can usually fail to work because of dirt buildup in the button itself.

Make sure to disconnect the controller from any electrical sources before beginning.

O que você precisa

  1. PowerA Spectra Contoller D-Pad Replacement, Rear Case: passo 1, imagem 1 %32

    • Flip the controller over so the backplate is facing up.

    Editar

  2. PowerA Spectra Contoller D-Pad Replacement: passo 2, imagem 1 %32

    • Use a Phillips #2 screwdriver to remove the eight 7.8 mm screws that secure the rear case.

    Editar

  3. PowerA Spectra Contoller D-Pad Replacement: passo 3, imagem 1 %32

    • Hold the front case in one hand and pull the rear case off.

    Editar

  5. PowerA Spectra Contoller D-Pad Replacement, D-Pad: passo 4, imagem 1 %32

    • Use a Phillips screwdriver to remove the two 7.8 mm screws securing the motherboard to the chassis.

    Editar

  6. PowerA Spectra Contoller D-Pad Replacement: passo 5, imagem 1 %32

    • Gently take the motherboard off of the front plate.

    Editar

  7. PowerA Spectra Contoller D-Pad Replacement: passo 6, imagem 1 %32

    • Use Phillips screwdriver to remove the four 7.8 mm screws that secure the D-pad.

    Editar

  8. PowerA Spectra Contoller D-Pad Replacement: passo 7, imagem 1 %32

    • Gently pry off the D-pad.

    Editar
Conclusão

To reassemble your device, follow the above steps in reverse order.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.

0Comentários do guia

Comentar

Visualizações:

Últimas 24 horas: 0

Últimos 7 dias: 6

Últimos 30 dias: 11

Ao todo: 122