Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Peças e ferramentas

Introdução

Be cautious when removing the back panel of the device. Buttons tend to become loose and fall out of place. Some force is necessary in removing the back and front panels.

Peças

Nenhum componente especificado.

  1. Use the T5 Torx screwdriver to remove the two 3.8 mm screws located in the back right corner of the device. Use the T5 Torx screwdriver to remove the two 3.8 mm screws located in the back right corner of the device.
    • Use the T5 Torx screwdriver to remove the two 3.8 mm screws located in the back right corner of the device.

  2. Using a plastic opening tool, pry off the back cover by going around the device until the panel is completely detached. Using a plastic opening tool, pry off the back cover by going around the device until the panel is completely detached.
    • Using a plastic opening tool, pry off the back cover by going around the device until the panel is completely detached.

  3. Use a T5 Torx screwdriver to remove the ten 4.0 mm screws lining the perimeter of the device.
    • Use a T5 Torx screwdriver to remove the ten 4.0 mm screws lining the perimeter of the device.

  4. Kits para o Nintendo Switch

    Um reparo rápido para reiniciar o jogo

    Confira kits para o Nintendo Switch

    Kits para o Nintendo Switch

    Um reparo rápido para reiniciar o jogo

    Confira kits para o Nintendo Switch
  5. Using the plastic opening tools, pry off the front panel of the device. Using the plastic opening tools, pry off the front panel of the device.
    • Using the plastic opening tools, pry off the front panel of the device.

  6. With your plastic opening tool, lift up on the connectors to disconnect them. With your plastic opening tool, lift up on the connectors to disconnect them.
    • With your plastic opening tool, lift up on the connectors to disconnect them.

  7. Remove the tape which holds the wiring to the battery using a plastic opening tool. Remove the tape which holds the wiring to the battery using a plastic opening tool.
    • Remove the tape which holds the wiring to the battery using a plastic opening tool.

  8. On the back side of the middle panel, pry the battery using the plastic opening tools. Use of force is necessary since the battery is glued down. Use of force is necessary since the battery is glued down.
    • On the back side of the middle panel, pry the battery using the plastic opening tools.

    • Use of force is necessary since the battery is glued down.

  9. Slide the connecting wire through the opening of where the battery was placed. Slide the connecting wire through the opening of where the battery was placed.
    • Slide the connecting wire through the opening of where the battery was placed.

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas concluíram este guia.

John Goly

Membro desde: 20/01/2015

421 Reputação

3 Guias de autoria

Equipe

USF Tampa, Team 11-5, Blackwell Winter 2015 Membro de USF Tampa, Team 11-5, Blackwell Winter 2015

USFT-BLACKWELL-W15S11G5

3 Membros

14 Guias de autoria

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 2

Últimos 30 dias: 8

Duração total: 1,859