Introdução

How to remove the LCD.

Peças

Não são necessárias peças.

Turn off the cell phone.
  • Turn off the cell phone.

Adicionar comentário

Press down on the round button on the back cover of the phone.
  • Press down on the round button on the back cover of the phone.

Adicionar comentário

Slide the back cover down while still pressing the button.
  • Slide the back cover down while still pressing the button.

Adicionar comentário

Remove the back cover.
  • Remove the back cover.

Adicionar comentário

Press the end of the battery towards the top of the phone.
  • Press the end of the battery towards the top of the phone.

Adicionar comentário

Lift the battery outwards while still pressing it upwards till it pops out.
  • Lift the battery outwards while still pressing it upwards till it pops out.

  • You may need to take several attempts to lift out the battery.

Adicionar comentário

Squeeze the flat end of the spudger into the crack right under the word "Nokia" on the back of the phone.
  • Squeeze the flat end of the spudger into the crack right under the word "Nokia" on the back of the phone.

  • This step may be a bit difficult if you are removing the antenna for the first time.

Adicionar comentário

Pry open the antenna door by pulling down the top of the spudger
  • Pry open the antenna door by pulling down the top of the spudger

Adicionar comentário

Remove the antenna door.
  • Remove the antenna door.

Adicionar comentário

If the gold antenna remained stuck to the door, you have finished removing the antenna from the phone.
  • If the gold antenna remained stuck to the door, you have finished removing the antenna from the phone.

  • If the gold antenna is still in the phone, carefully remove it and stick it onto the back of the door.

  • Try to keep the antenna as flat as possible. Do not bend it.

Adicionar comentário

Remove the five screws with the Torx Screwdriver: two near the bottom, two in the middle, and one under the antenna door.
  • Remove the five screws with the Torx Screwdriver: two near the bottom, two in the middle, and one under the antenna door.

  • The two bottom screws are longer than the upper three.

Adicionar comentário

Remove the back covering.
  • Remove the back covering.

Adicionar comentário

Remove the two screws at the top.
  • Remove the two screws at the top.

Adicionar comentário

Remove the metal plating and the circuit board.
  • Remove the metal plating and the circuit board.

  • There is nothing holding the rest of the phone together. Handle the rest of the phone carefully.

  • The LCD will be attached to the circuit board.

Adicionar comentário

Detach the LCD from the logic board at the four metal hinges.
  • Detach the LCD from the logic board at the four metal hinges.

  • There are three pieces to the LCD: the front metal border, the LCD unit, and the plastic backing. Unless you are replacing the LCD, do not separate these three pieces.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Aaron Jen

Member since: 11-04-2010

1 reputação

14 Guides authored

Equipe

Cal Poly, Team 27-94, Amido Spring 2010 Membro de Cal Poly, Team 27-94, Amido Spring 2010

CPSU-AMIDO-S10S27G94

4 Membros

14 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 3

Todo: 2,708