Logitech Harmony Smart Keyboard Back Panel

Última atualização em November 11, 2022

10 - 15 minutos

Fácil

Introdução

This is a prerequisite guide that will instruct you on how to properly open your keyboard. This will be helpful for replacing internal components without damaging your device.

O que você precisa

Ferramentas

Exibir mais…

Passo 1 Back Panel

Logitech Harmony Smart Keyboard Back Panel, Back Panel: passo 1, imagem 1 %32

Logitech Harmony Smart Keyboard Back Panel, Back Panel: passo 1, imagem 2 %32

Turn keyboard over to the backside.

Editar

Passo 2

Logitech Harmony Smart Keyboard Back Panel: passo 2, imagem 3 %32

Press and slide up on the upper battery latch, using both thumbs.

Editar

Passo 3

Remove the two AA batteries and set them aside.

Editar

Passo 4

Unscrew all five 4.0 mm screws, using Phillips #1 screwdriver.

Editar

Passo 5

Peel off the center sticker to reveal two hidden 4.0 mm screws.
Unscrew these two screws with a Phillips #1 screwdriver.

Editar

Passo 6

Logitech Harmony Smart Keyboard Back Panel: passo 6, imagem 3 %32

Lift both top left and top right rubber stickers halfway, using the sharp end of the plastic spudger.
Unscrew a total of two 4.0 mm screws, under the rubber stickers, using a Phillips #1 screwdriver.

Editar

Passo 7

Unscrew the top center 4.0 mm screw, in the battery compartment, using the Phillips #1 screwdriver.
Now, you should have a total of ten 4.0 mm screws set aside.

Editar

Passo 8

Logitech Harmony Smart Keyboard Back Panel: passo 8, imagem 3 %32

Wedge the flat end of the spudger between the back panel and front panel.
Slide the flat end of the spudger from right to left to pry the two panels apart.

Editar

Passo 9

Logitech Harmony Smart Keyboard Back Panel: passo 9, imagem 3 %32

Separate the back panel from the front panel completely, using both hands.
A white ribbon flex cable will remain connected to both panels.
Pull the panels apart slowly and gently, or the white ribbon flex cable may be unsafely removed.