Introdução

This guide will help you replace the logic board.

Make sure you remove the battery by lifting the tab on the back of the phone before opening the case.
  • Make sure you remove the battery by lifting the tab on the back of the phone before opening the case.

  • Poke out rubber covers using a spudger or pointy object, such as a thumb tack.

Adicionar comentário

Use a T6 torx screwdriver to unscrew the 6 screws that hold the back casing on.
  • Use a T6 torx screwdriver to unscrew the 6 screws that hold the back casing on.

Adicionar comentário

Use IPod opening tool to separate back housing.
  • Use IPod opening tool to separate back housing.

  • There are two tabs located on either side of the phone.

Adicionar comentário

Separate the back housing from the phone.
  • Separate the back housing from the phone.

  • Be careful not to rip out the wire (highlighted in yellow) when separating the back housing.

Adicionar comentário

Use a spudger to disconnect antenna wire.
  • Use a spudger to disconnect antenna wire.

Adicionar comentário

Use the IPod opening tool to pop out the logic board.
  • Use the IPod opening tool to pop out the logic board.

Adicionar comentário

Use the IPod opening tool to disconnect the main ribbon.
  • Use the IPod opening tool to disconnect the main ribbon.

Adicionar comentário

Once the ribbon is detached, remove the logic board and replace if necessary.
  • Once the ribbon is detached, remove the logic board and replace if necessary.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Joshua Herrmann

Member since: 16-04-2010

8 reputação

16 Guides authored

Equipe

Cal Poly, Team 6-14, Maness Spring 2010 Membro de Cal Poly, Team 6-14, Maness Spring 2010

CPSU-MANESS-S10S6G14

4 Membros

16 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Todo: 1,148