Peças

Não são necessárias peças.

  1. Flip the projector right-side up and turn it so that the back ports are facing you.
    • Flip the projector right-side up and turn it so that the back ports are facing you.

    • Remove the 7mm metallic hex screws using the flat-head screwdriver.

    • Remove the two black 10mm screws using the T10 Torx screwdriver head. The screws are located at the center of the back panel.

    Adicionar comentário

  2. Flip the projector over.
    • Flip the projector over.

    • Remove the two 77mm screws that are located nearest to the back panel ports. Use the T10 Torx screwdriver head.

    • Next, remove the two 10mm screws located near the lens side with the T10 Torx screwdriver head.

    • Flip the projector back over.

    • Lift up the main lid cautiously to avoid ripping the electrical ribbons.

    Adicionar comentário

    • Unplug the speaker wire from the circuit board by simultaneously squeezing the sides and pulling.

    • Pull on the brown tabs located at the sides of the white plastic ribbon holder and pull the ribbon out.

    • Pull the top cover back.

    Adicionar comentário

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove the cables from the white tabs.

    Adicionar comentário

    • Remove the five 5mm screws located throughout the motherboard with the screwdriver. Use the T10 Torx screwdriver head.

    • Pull up on each metal tab located at the rear of the projector. There are 5 tabs.

    • Do not pull up on the metal tabs too hard or too fast because they can break easily.

    Adicionar comentário

    • Remove the three gold ribbons by flipping up the black taps that hold the ribbon in place.

    • Pull the ribbons out carefully and place them under the main board.

    • Carefully lift the entire main board up.

    Adicionar comentário

    • Once the main board has been removed, carefully lift the fans upward. Make sure no cables are tangled in the process.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Jorge L Navarro

Member since: 22-01-2014

533 reputação

5 Guides authored

Equipe

Cal Poly, Team 13-17, Regan Winter 2014 Membro de Cal Poly, Team 13-17, Regan Winter 2014

CPSU-REGAN-W14S13G17

6 Membros

5 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 1

Últimos 30 dias: 20

Todo: 1,067